Light Sources Installing Chandelier

Installation of chandeliers can be called a fairly simple operation and, among other things, is one of the most important elements of the decor of the room. Also, special attention should be paid to quality fasteners to chandelier does not become a source of danger for you. Once the plug or turning off the circuit breaker, it is necessary to check whether are suitable for use hook chandeliers and wiring. Currently, widespread technology attachment chandeliers to the ceiling, while the hook is simply not needed. Chandelier, you can connect using the terminals. But due to the fact that the terminals in terminal block located on a fairly close to each other, to ensure that insulation reaches the terminals. In the case where the conductor bared too much, then they should be cut with wire cutters or pliers, and then hold in the terminals.

After of how this work will be done you can screw the plug back and turn the circuit breaker, and then a special device to determine if there is power when the circuit breaker. Sometimes it happens that one of the wires when you turn is energized, regardless of whether the switch is enabled or not. However, the chandelier you still can normally turn on and off. This is a consequence of the fact that when paving the network by mistake to the chandelier was installed earthed. If this happens, then both wires into the Wye outlet or junction box must be easy to swap. If you still got chandelier, which is attached to the ceiling with hooks, this hook should be a certain length, and the cap chandeliers – completely cover and terminals, and wires.

Hook is quite possible to cut or angle grinders grinder machine If it is too large in length, and if such a tool at hand is not, then it can podpilit and broken off, and then re-bend Pliers. When the chandelier is suspended, its two wires should tighten screws in the terminal block, since you can screw a plug or circuit breaker. If the chandelier is designed for a large number of lamps, a chandelier can be connected by cascading switch. The fact is that often the maximum lighting in the room is simply not needed. Typically, in such a situation, the number of lamps is halved. To implement the separate inclusion of lamps, and used a cascade switch. All three wires should be used in case cascading two of them are designed to connect two groups of lamps, and a third is in this case, the common wire. In the very chandelier lamp should unite only in groups and out to make a conclusion with using three or four strands. If there are only three wires, then it may mean that two of the invisible veins have been merged as one conductor brought out. If, however, in the presence of all four cores, then the two of them, that is, from each group, one must be connected together and will need to bring to one terminal in the terminal block. Thus will be formed as a general provod.Esli all three wires that go from the ceiling, matted together, they should be prvereny flat screwdriver, putting the switch to a different position. No matter what position the switch is known to be earthed not zazhget gas-discharge tubes.